Benachrichtigungen
Alles löschen

Dragging through layer  

  RSS
Jonathan Leek
(@jonathan-leek)
New Member
Dragging through layer

My first layer seems to go down ok, but subsequent layers look like they are dragging through what's already there, accompanied by a knocking noise. Have already run z calibration a couple of times

Veröffentlicht : 01/02/2023 10:09 pm
Diem
 Diem
(@diem)
Illustrious Member

What filament is this?

Occasionally results like this occur when printing a gcode intended for a different filament..?

Cheerio,

Veröffentlicht : 02/02/2023 1:30 am
Jonathan Leek
(@jonathan-leek)
New Member
Themenstarter answered:
RE: Dragging through layer

A few cold pulls fixed the issue, must have been something inside the nozzle.

Veröffentlicht : 02/02/2023 4:06 pm
Teilen: