Notifications
Clear all
Dragging through layer
My first layer seems to go down ok, but subsequent layers look like they are dragging through what's already there, accompanied by a knocking noise. Have already run z calibration a couple of times
Posted : 01/02/2023 10:09 pm
What filament is this?
Occasionally results like this occur when printing a gcode intended for a different filament..?
Cheerio,
Posted : 02/02/2023 1:30 am
Topic starter
answered:
RE: Dragging through layer
A few cold pulls fixed the issue, must have been something inside the nozzle.
Posted : 02/02/2023 4:06 pm