Notifications
Clear all

disappointed with the mk3s  

  RSS
leandro.pitta
(@leandro-pitta)
New Member
disappointed with the mk3s

Hello from me,

I upgraded my Prusa Mk3S to the Mk3S+ in the last few days. Everything fine. I also installed a new hotend (complete) and of course oiled all bearings etc.

Now I realized that I have relatively imprecise prints. So I wanted to print a Calibration Cube with Prusament PETG and this is what came out:

The walls have very strange structures. I can't understand why they look like this.

What could that be? I cleaned the nozzle and did a cold pull.

Opublikowany : 06/07/2022 8:04 am
Diem
 Diem
(@diem)
Illustrious Member

That looks like damp filament.

Cheerio,

Opublikowany : 06/07/2022 10:09 am
leandro.pitta
(@leandro-pitta)
New Member
Topic starter answered:
RE: disappointed with the mk3s

Yes, I also thought about bad filament however it is Prusament, ordered 2 weeks ago and opened yesterday for the first time?

Have just no other at hand.

Opublikowany : 06/07/2022 11:27 am
JustMe3D
(@justme3d)
Honorable Member
RE: disappointed with the mk3s

 

Posted by: @leandro-pitta

Hello from me,

I upgraded my Prusa Mk3S to the Mk3S+ in the last few days. Everything fine. I also installed a new hotend (complete) and of course oiled all bearings etc.

If you don´t mind my asking, did you run a complete new installation cycle, given that none of the old Z values etc. will work anymore with a new SuperPINDA and new hotend?

Cheers

Chris

I try to give answers to the best of my ability, but I am not a 3D printing pro by any means, and anything you do you do at your own risk. BTW: I have no food for…

Opublikowany : 06/07/2022 12:44 pm
leandro.pitta
(@leandro-pitta)
New Member
Topic starter answered:
RE: disappointed with the mk3s

Yes, i reseted the printer and started from new. I went through the setup assistant and everything.

Opublikowany : 06/07/2022 12:46 pm
JustMe3D polubić
Diem
 Diem
(@diem)
Illustrious Member

opened yesterday for the first time?

In the wrong climate conditions filament can absorb enough water to cause trouble in just a few hours, sometimes within the timespan of one print.

Cheerio,

Opublikowany : 06/07/2022 2:11 pm
Share: