Dialing in bed leveling

Dernier message

RSS

Ron

(@ron-5)

New Member

Dialing in bed leveling

I am trying to dial in my bed leveling as I feel like I am always having to adjust the Live Z. Here are some readings I just took from pronterface and plugged into the heatmap python script. If I am reading this correctly it looks like the bed is getting higher towards the middle? Any help or suggestions would be greatly appreciated.

Thanks

Publié : 04/10/2023 5:25 pm

Statistiques du forum

565 Forums

63.7 K Sujets

446.6 K Messages

26 En-ligne

69.1 K Membres

Le dernier des messages: Xl extruder stops Notre nouveau membre: KaptainAhoibrause Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé