Notifiche
Cancella tutti
Curved frame
Hello
After twisting the whole frame of the European instruction in this part, it was in the middle of its fourth,
and here I have a problem because the right front corner of the printer,
is about 0.5 mm higher and the printer is unstable, it moves sideways even after installing anti-vibration feet,
and here is my question, is it the wine of my choice that I turned the profile,
turned it, loosened it or the profile is cut crookedly and is there any way to do it?
Questa discussione è stata modificata 4 years fa da godlike20
Postato : 29/09/2020 7:40 pm
Postato : 02/10/2020 12:38 am