Completed build - mystery part
Hello all,
I have finished building my printer. Test prints look very good, and the whole thing works fine.
After completing the build, I located this part on my floor (see photo below, USB device for scale) - I believe it is from the printer's box and parts. So, it was not placed into any part of the extruder or axis drives. I can't find any mention of it in the manual.
What part is this (and how worried should I be)? Thanks for any help.
Best Answer by Antonio:
I'm quite sure that part is not from the printer.
RE: Completed build - mystery part
I'm quite sure that part is not from the printer.
I'm not an expert. Ma parlo anche italiano 😉
RE: Completed build - mystery part
That is not a part of the Prusa printer.
RE: Completed build - mystery part
@antonio-da-catania
Thanks to both of you. Glad to hear this and put my mind at ease!
RE: Completed build - mystery part
That looks like a piece from the feeder for an Ultimaker printer.