Notifiche
Cancella tutti
Calibration -> First layer cal doesn't work
I just finished the mounting of my new i3 MK3S+ . I've made all claibration but the first layer calibration doesn't work. The head move on the bed drawing the first layer but not filament is going out from the nozzle. What's wrong ?
Postato : 27/11/2021 8:35 pm
RE: Calibration -> First layer cal doesn't work
Does the filament come out of nozzle when you load the filament?
[Mini+] [MK3S+BEAR]
Postato : 27/11/2021 8:46 pm
Topic starter
answered:
RE:
Answer from the support : the sensor wasn't pluged at the right place on the motherboard. It should be connected on the second row 😀
Questo post è stato modificato 3 years fa da Sébastien
Postato : 27/11/2021 9:49 pm