Notifications
Clear all
Bumpy Surfaces
Just got my printer today. It was a fully assembled kit. I plugged it in, did an xyz calibration and ran my first print (shown below). The surfaces seem to have some periodic bombs to them. Any idea what is going on? 
Publié : 12/03/2020 9:32 pm
RE: Bumpy Surfaces
Every time the extruder moves up to a new level, you get a little bump.
In PrusaSlicer you can specify how you want these level transitions to occur. All in a line, random, etc.
Publié : 12/03/2020 10:53 pm