Benachrichtigungen
Alles löschen
Benchy print failure
EDIT: images are failing to upload from my mobile device. Will need to upload later.
My benchy prints are failing around the same place, trying to figure out if the possible source.
See attached photos.
Best Answer by erik:
looks like your z offset is too high. Diem gave me good advice to print the z offset calibration test layer until the last part shows and a solid layer.
Dieses Thema wurde geändert Vor 2 years von Geo1978
Veröffentlicht : 25/01/2023 2:42 am
Themenstarter answered:
RE: Benchy print failure
Photos below of the Benchys
Veröffentlicht : 25/01/2023 5:07 am
RE: Benchy print failure
looks like your z offset is too high. Diem gave me good advice to print the z offset calibration test layer until the last part shows and a solid layer.
Veröffentlicht : 25/01/2023 2:35 pm
Themenstarter answered:
RE: Benchy print failure
Yep, I thought it looked good and I was already at the edge, but found out I was off by 30%. Thank you!
Veröffentlicht : 25/01/2023 11:20 pm