Bed not level
I have 4 of the Mk3 that where preassembled. I have noticed on 3 of them that the bed really hasnt been level from day 1. The 4th machine is ok but not great. I have ran the setup wizard multiple times with no changes.
Each machine has probably ran 100 print hours each with me just getting by on using the center of the bed. If I try to go any larger I run into the same problem. The top of the bed is generally too high and the bottom (mainly bottom left is too low). Please see attached pictures. I have 3 of the CR10's and was really looking forward to auto bed leveling but my experience has not been great. Any ideas would greatly be appreciated.
Re: Bed not level
Contact support with a chat. They will be able to trouble shoot if you need to replace anything.
--------------------
Chuck H
3D Printer Review Blog
Re: Bed not level
Or have a look at this thread ... https://shop.prusa3d.com/forum/assembly-and-first-prints-troubleshooting-f62/bed-leveling-issue-right-side-higher--t23790-s20.html ... 7x7 mesh bed leveling worked for me nicely.
Cheers,
Mark
———————————————
MK3 kit B7-R3 / custom FW v3.5.1 with 7x7 MBL
Slic3r PE v1.41.2
Re: Bed not level
Thanks for the help. Took some figuring out how to do the 7x7 leveling but it works like a champ. No issues now. Why isn't this standard?
Re: Bed not level
Thanks for the help. Took some figuring out how to do the 7x7 leveling but it works like a champ. No issues now. Why isn't this standard?
It's coming, see this posted a few days ago.