Bed Leveling Print Messed Up
Hi everyone,
I just got the MK3S+, tried printing the official bed leveling model resulted in a heavily scarred center square and acceptable middle right and lower left corner. Is this a bed leveling problem, or something else (belt tension, warp bed plate, etc…)?
Thanks for any insight!
To me that looks like the nozzle needs to be closer to the bed and maybe clean the bed.
Clean the bed with dish soap and lots of hot water.
Nothing about any of those look acceptable to me. Advice = hot soapy water, handle only by edges. Then enable 7x7 bed mesh leveling in the settings. Then read life adjust Z my way thread.
Nylock Bed Leveling?
Soap washed & alcohol wiped the bed, a little better but still seeing similar result where the square in middle of the bed has large gaps and the sides of the bed has smaller/none gaps. Thinking about doing the nylock bed leveling mod, is that still recommended for MK3S+?