Clear all

Bed leveling issue  

New Member
Bed leveling issue


I hope someone can help me last week I got a net MK3S kit, and have had some issues getting good prints out of the unit.  Since I'm new to 3D printing I charked it up as a learning curve and keep plugging away.  Over the last couple of days, I have been working with the unit trying to get consistent prints, and have been making adjustments to the PINDA sensor.  During my first set up the right side of the printer was catching with the Z calibration.  So I moved the Pinda sensor up and ran again, this time the nozzle did not catch.  After a couple of days of printing ok prints, I started to have issues with PET, and did another first layer calibration.  This time I noticed that the right side of the bed was lower than the left side of the bed.  No matter what I do I can not figure out how to get the right side of the bed to be level with the left side.

I have looked around and have found others with this issue over the years, but have not been able to find a solution to the issue yet.   Any help would be very much appreciated.


Posted : 07/05/2020 2:41 am