Notifications
Clear all
Bear extruder with a sunon fan. Still have inconsistence extrusion.
What can I do at this point? I cant use either of my MK3S's for cosmetic things like lithophanes because of this.
Opublikowany : 24/04/2019 3:10 pm
RE: Bear extruder with a sunon fan. Still have inconsistence extrusion.
Hmmm,
I think, this is not exactly the right place. I don't know if PRUSA is supporting the BEAR-mods ?
Try to get help in the BEAR-mod facebook group from Greg https://www.facebook.com/groups/prusabearupgrade/
(I have an BEAR too 😉 )
Thomas
This post was modified 6 years temu 2 times by Knickohr
Opublikowany : 25/04/2019 8:43 am
RE: Bear extruder with a sunon fan. Still have inconsistence extrusion.
Make sure your litho is well supported with a brim and some diagonal end supports in the thin dimension. When printed vertically like this they have a tendency to wobble and cause this.
Opublikowany : 25/04/2019 11:18 am