Notifications
Clear all
Bad print
Prusa i3 MK3S. I have used different filament, PETG, PLA etc but this always prints like this. I have tried levelling the bed, applying glue to the printing sheet, all to no avail. Here is the result.
Any help will be greatly appreciated.
Opublikowany : 15/10/2022 7:00 pm
RE:
I think you are printing mid-air. Lower your Live-Z value
Also try to clean the sheet with dishsoap and warm water, gluestick shouldn't be needed.
I'm not an expert. Ma parlo anche italiano 😉
Opublikowany : 15/10/2022 7:06 pm
Topic starter
answered:
RE: Bad print
Antonio.
That was excellent. It took me about seven attempts to get it right and ended up lowering the print head by 0.500 !!
You're a diamond, and thank you.
Opublikowany : 16/10/2022 9:48 am