Notifications
Clear all
Auto-home P.I.N.D.A. Test
I assume this is a dumb question but I'm brand new to 3d printing so please forgive me. When I run the 'paper test' the nozzle grabs the paper, so I'm now running Calibration - AutoHome. The PINDA stops within the circle but I feel like the back-left part of the PINDA is on the edge of the circle (see attached image). Is this considered OK?
This topic was modified před 5 years 2 times by JohnnyNumber6
Napsal : 16/04/2020 10:08 pm