Assembling Z-Top got me Stuck
Hello,
I got to the step where I'm supposed to mount the Z-Top and I realized something seems uneven because the Z-tops seem to be difficult to mount to the frame without forcing them. I look for the reason and then I realize that when I place the X-Axis on the lead screws, without screwing anything in, the left side is slightly lower than the right side. I have pictures below:
What could be the reason for this? I appreciate the help. I unmounted and mounted back the Z-Motors, but it's the same result.
Re: Assembling Z-Top got me Stuck
Hi Maxwell,
screw the Z leadscrews so that the X ends go down far enough to fit your Z ends,
X axis levelling is dealt with, later in the build sequence!
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Re: Assembling Z-Top got me Stuck
https://www.prusa3d.com/new-user-mk3/
it's about 3:29 on the video
Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Re: Assembling Z-Top got me Stuck
https://www.prusa3d.com/new-user-mk3/
it's about 3:29 on the video
Joan
Thanks a lot, Joan. I've moved on.
Re: Assembling Z-Top got me Stuck
😀
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK