Benachrichtigungen
Alles löschen
3rd layer failed , any idea why ?
Hi
After fist and second layer printed OK, the third one failed, any idea why? Everything was cleaned before this print, filament is Fiberlogy Easy PLA, nozzle 0.4, temp 220 degrees as this filament seem to do better at this temperature.
Best regards,
Daniel
Veröffentlicht : 04/07/2020 8:28 am
RE: 3rd layer failed , any idea why ?
You have everywhere gabs, your first layer is to high. Make a new first layer and make a picture, only from the first layer.
Clean bed with dish soap, and print.
Veröffentlicht : 04/07/2020 4:01 pm