Notifications
Clear all
"Late" warp to the X/Y "inside"...?
Hello everybody,
I am using my MK3S+ since about one year and mostly with PLA. This is my fourth ABS piece and (including this one) I had - after calibration - no first layer issues. So first layer here does look good too and there is no warp UP from first layer at all: so it shouldn't be an adhesion issue. Even inside the little box everything looks very perfect to me, but outside it's warped. The box is about 5 x 5 x 1 cm in size. Interestingly I printed this box before about half the size and it wasn't warped.
Any ideas?
🙁
Help would be really appreciated
t
Opublikowany : 08/05/2023 6:31 pm