Notifications
Clear all
Overextruding at start of print
It seems to start oozing before its printed it's first line during the warm up, it will print acceptably if I can clear this away from the first layer or it does not later fall onto the model.
I am using a new sealed Prusament PLA, but this is happening with other brands too.
I have found some threads that sound similar to this but they are dated 2018 and I'm not sure the code based fixes would work correctly.
Any advice greatly appreciated.
Posted : 19/06/2023 8:54 am
RE: Overextruding at start of print
I have the same problem.
Really need for help!
Posted : 28/07/2023 3:36 am