Notifiche
Cancella tutti

Upgrade to 3.5 or 3.9  

  RSS
Rusty Jones
(@rusty-jones)
Eminent Member
Upgrade to 3.5 or 3.9

Well, it's time to upgrade, I think. I have a MK3s+ with a MMU3. it is working fine, but I would like to speed it up a bit, and better prints would be nice as well. All I have read says an upgrade to MMK3.5 will do this. So I think I am at least going that far, so my question is, should I go to 3.9 and get the Nextruder as well? Those of you with the 3.9 upgrade, how is it going for you? any issues using the MMU3 with it? I know from a chat with support that I need a parts kit to make the MMU3 compatible with the 3.5, and 3.9. Other than that how is the upgrade?

 

Thanks!

Postato : 22/07/2024 5:52 pm
Protoncek
(@protoncek-2)
Eminent Member
RE: Upgrade to 3.5 or 3.9

My opinion is that any upgrade is ... well, i won't say waste of money, but rather "not a good idea". Why? You end up with a bunch of parts which are useless and you have no options to use them.

I'd rather buy a new MK4 and sell MK3+. But that's just me...

Postato : 23/07/2024 4:45 am
Owens2303 hanno apprezzato
Condividi: