Avisos
Vaciar todo

XYZ Calibration  

  RSS
larry.s
(@larry-s)
Active Member
XYZ Calibration

So I updated my firmware to the new 3.0.6 a few days ago and wanted to test the new xyz calibration. Every-time I run it though it fails. Even though the printer seems to be printing will with no issues. Is there a way to see where the failure is?

Does anyone have any idea why it would fail if it seems to be printing fine with no issues?

I'm at a loss.

Thanks.

Respondido : 26/08/2016 7:15 pm
David T.
(@david-t)
Noble Member
Re: XYZ Calibration

We still don't know how it fails. What does it do? What does it show on display? Information, information.

Respondido : 26/08/2016 7:22 pm
larry.s
(@larry-s)
Active Member
Topic starter answered:
Re: XYZ Calibration

I'll have to rerun it again tonight to get exact message but it give no indication of why it failed. Just says something like "calibration failed or something to that affect".

Just thought I would see if was missing something.

Respondido : 26/08/2016 7:29 pm
Vojtěch Bubník
(@vojtech-bubnik)
Miembro Admin
Re: XYZ Calibration

Please check the following topic:

http://help.prusa3d.com/mk2-movement-calibration/calibrate-x-y-info-and-errors

Vojtech

Respondido : 29/08/2016 12:06 pm
larry.s
(@larry-s)
Active Member
Topic starter answered:
Re: XYZ Calibration

I will take a look.

I did flash the 3.0.7 today and try again and no matter what I do currently the xyz fails and says to consult the manual. I just wish I could get an idea of what's the issue is as its been printing fine. I'll check that link though.

Respondido : 30/08/2016 2:49 am
Compartir: