TPE NOT sticking to PEI
I'm having problems getting TPE to stick to the heatbed (PEI on mk2s), which seems to be the exact opposite of what everyone else has problems with.
The ends of my print start lifting and eventually the whole thing comes loose before it's done.
I've gotten the bed up 110C so far, used glue, not used glue. Not sure what else to try.
Anyone else experience this?
Re: TPE NOT sticking to PEI
Admins: could you please delete this thread? Posted in the wrong place...
Re: TPE NOT sticking to PEI
Well, as a moderator, I just tried, but I can't.
Best solution is to report your own post and hope that one of the admins looks at reported posts occasionally.
Sorry.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: TPE NOT sticking to PEI
Thanks Peter.