English
Forums
English forum
Original Prusa i3 MK2/S
Others (Archive)
TPE NOT sticking to PEI
 
Notifications
Clear all

TPE NOT sticking to PEI  

    Last Post
  RSS
Scryptonian
 Scryptonian
(@scryptonian)
Eminent Member
TPE NOT sticking to PEI

I'm having problems getting TPE to stick to the heatbed (PEI on mk2s), which seems to be the exact opposite of what everyone else has problems with.

The ends of my print start lifting and eventually the whole thing comes loose before it's done.

I've gotten the bed up 110C so far, used glue, not used glue. Not sure what else to try.

Anyone else experience this?

Posted : 14/09/2017 3:09 pm
Scryptonian
 Scryptonian
(@scryptonian)
Eminent Member
Topic starter answered:
Re: TPE NOT sticking to PEI

Admins: could you please delete this thread? Posted in the wrong place...

Posted : 15/09/2017 7:46 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: TPE NOT sticking to PEI

Well, as a moderator, I just tried, but I can't.

Best solution is to report your own post and hope that one of the admins looks at reported posts occasionally.

Sorry.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 15/09/2017 8:02 pm
Scryptonian
 Scryptonian
(@scryptonian)
Eminent Member
Topic starter answered:
Re: TPE NOT sticking to PEI

Thanks Peter.

Posted : 16/09/2017 11:51 am
  All forum topics
  Previous Topic
Next Topic  
Share: