Notifications
Clear all

too much heat from bed ?  

  RSS
matt.w9
(@matt-w9)
New Member
too much heat from bed ?

Hi,

I have been having trouble with my prints at 0.1 layer height, I get almost a burnt affect on any overhangs which occur fairly low down, these mainly occur on any side of the print where the nozzle fan won't get to.

I get the same affect when I try and print Benchy, same scenario, on overhangs

Is the nozzle fan duct considered adequate ?

Am I missing anything ?

thanks

Napsal : 31/10/2017 11:14 pm
Share: