Notifications
Clear all
Suddenly stringing? (didn't do so in the past)
Hi just like my title says I am suddenly experiencing a noticeable amount of stringing since the new year, I did travel and had to setup my prusa again since the Christmas break but it was safely secured in my car's back seat so I am pretty sure it did not get damaged. I have checked the belt tension, performed cold pulls to check for jams/clots, tweaked with my slicer's settings but I just can't seem to figure out what is causing this. Does anyone have any suggestions for me on what to look at? because I am lost.
Opublikowany : 16/01/2018 7:23 am