Stringing Only at 0.05. Flow Issue?

Dernier message

RSS

Cultura Mat3ri...

(@cultura-mat3rial)

Active Member

Stringing Only at 0.05. Flow Issue?

Hi.

I've been noticing that the smaller the layer height the more stringing effect is noticeable.

Might it be a flow issue or something with the speeds? Since extrusion multiplier, retraction and wiping settings are the same for all layer heights I don't see where's the problem.

Thanks!

Publié : 06/06/2017 9:37 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

22 En-ligne

68.1 K Membres

Le dernier des messages: Poll - Should Prusa make the $299 MK4S -> Core One voucher available to all who purchsed the MK4S or MK4 to MK4S upgrade kit. Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé