Notifications
Clear all

Quite a problem  

  RSS
CellarDoor
(@cellardoor)
Eminent Member
Quite a problem

Yes I know you should not leave your print alone for a longer while, and I just got my printer this week 🙁
However I was distracted by a phone call, though already quite sure the first layer stuck - an now I have big blob (really big!) at the bottom of my hot end, when I came back. I am heating again now, put it got stuck I fear 🙁

Any ideas? I just wanted to work on improving adhesion, and read about PINDA - but for now my hot end really seems to be fixed in ABS.

I am really angry at myself and hope i don't need a new hotend 🙁

Napsal : 07/09/2017 10:34 pm
Share: