Printer losing x/y orientation during prints
 
Benachrichtigungen
Alles löschen

Printer losing x/y orientation during prints  

  RSS
CoyDK
(@coydk)
Eminent Member
Printer losing x/y orientation during prints

I have been having a few issues with the printer losing its orientation when printing as shown in the picture. It was normally only on +18 hour prints it would happen but now it happens even early on.
Anyone know what might be the cause of this?
I run the X/Y + Z calibration before every print and clean the bed exc.

Veröffentlicht : 18/08/2016 4:13 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Printer losing x/y orientation during prints

Loose grub screw on a belt pulley motor spindle; quiet mode.

One of those is usually the culprit.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Veröffentlicht : 18/08/2016 6:23 pm
Teilen: