Notifications
Clear all
Print time estimates in prusaControl incorrect
I just updated to the latest prusaControl software (0.9.4_415_beta) and reflashed my mk2S to 3.1 firmware. Everything went smoothly and print quality is much better with linear advance but the print time estimate in prusaControl is now way under by about 30% (e.g. estimate 3hr, actual 4hr). Previously with v0.9.2 the estimate was bang on to the minute every time. The settings I was using were:
Original Prusa i3 Mk2
0.4mm nozzle,
Prusa PLA,
0.15mm layer height
30% infill,
No supports
Brim off
Any ideas as to what's causing this or if there's any way to fix it? Has there been some mixup with the mk3 settings somewhere?
Publié : 26/11/2017 4:01 pm