Notifications
Clear all
Please Help
Ever since updating my firmware the calibration procedures are not working. It does not go through calibrate Z, I see no calibrate XYZ, during the printing of CalibrationV2.gcode the nozzle touches the bed and while trying to print the carriage gets half way across the print bed and stops like it has been jammed.
George from Georgia. Savannah, GA
Publié : 27/11/2017 6:43 pm
Re: Please Help
I would contact Prusa on this they may know of a solution.
Publié : 27/11/2017 7:45 pm