Benachrichtigungen
Alles löschen

New: 3.0.8 Firmware released...  

Seite 3 / 3
  RSS
mark.s3
(@mark-s3)
Active Member
Re: New: 3.0.8 Firmware released...

Has 3.0.8 been tested with the Mk1 hardware, or is it for MK2 printers only? The RelNotes don't say either way ....

Veröffentlicht : 12/09/2016 10:11 pm
3Delight
(@3delight)
Moderator Moderator
Themenstarter answered:
Re: New: 3.0.8 Firmware released...

MK2 only. It tells you on the drivers page here: http://www.prusa3d.com/drivers/ :

Firmware 3.0.8 (September 1, 2016)

MK2 only for now, please re-run the V2calibration right after upgrade.

Veröffentlicht : 12/09/2016 10:13 pm
mark.s3
(@mark-s3)
Active Member
Re: New: 3.0.8 Firmware released...

If there was a period after the word 'now', I would agree with you. However, there is a comma there and not a period - which allows for two different interpretations.

1) Run the V2calibration routine right after upgrading MK2 systems. Don't run it on MK1 systems after upgrading.
or
2) Upgrade mk2 systems only. Always run the calibration routine.

The comma implies interpretation #1, which is why I asked the question. 🙂

Veröffentlicht : 12/09/2016 11:36 pm
Nicolas
(@nicolas-6)
Eminent Member
Re: New: 3.0.8 Firmware released...

Maybe the sentence is not clear, but if you download the zip, there are only MK2's files.

Veröffentlicht : 13/09/2016 9:45 am
3Delight
(@3delight)
Moderator Moderator
Themenstarter answered:
Re: New: 3.0.8 Firmware released...

Just a a note to all, please remember that Prusa Research is in the Czech Republic so English is not their first language.

As Darknico said only MK2 files are present in the zip for version 3.0.8 at this time... which kind of gives the game away! 😀

Veröffentlicht : 13/09/2016 1:21 pm
Seite 3 / 3
Teilen: