Notifications
Clear all
"Move Z" option messes up Z calibration?!?
Hi, all!
Occasionally I use the "Move Z" option to lift the printing head, so I could clean it up. I have noticed on several occasions that after doing that, the head crashes at [0,0] once I start printing or select "Auto Home". I usually then have to redo the XYZ Calibration, but it's a major pain in the neck.
Has anybody else noticed that, and what's the story with that issue?
EDIT: Now I see that the latest Firmware 3.0.11 (not installed it yet) addresses the following issue, that might have been causing the problem:
Stopping print right at the end of heatbed/nozzle preheat phase at the beginning of print could led to crashing nozzle into heatbed. This has been fixed.
Thanks,
Jonnie
Publié : 29/05/2017 1:59 pm