Notifications
Clear all
Layer addhesion
I have some problems getting layers to bond.. i have tried different temp settings but im up to 220 now and experiencing stringing...
Could it be the prusa fan that are to powerfull for this filament?
Posted : 10/01/2017 3:14 pm
Re: Layer addhesion
Which filament?
Without seeing photos I would think that the most likely culprit would be under-extrusion.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Posted : 10/01/2017 4:34 pm