Its 1st of June  

Re: Its 1st of June

I would assume they would start shipping in the order in which they were received, (im sure they had a large amount ordered) and i'd doubt they would all ship the same day 🙂

Re: Its 1st of June

I was only kidding 😀 Those that ordered the upgrade with have to wait. Qudos to Prusa for offering this route.

Re: Its 1st of June

I ordered mine on the 15th of May. I wonder how many were ordered and how many are in stock to ship? My favorite thing about the new kit is NO MORE ABS juice or Kapton tape. I know there is a lot more to the kit but, almost all my prints are in ABS.

Re: Its 1st of June

@scott I have abandoned ABS, I now use Ngen from colorfabb, as good as ABS without the shrinkage. The new PEI bed or Printbite here in the UK I have been using on 3 of my other printers with success. No more glue, no more ABS juice no more hairspray 🙂 Getting the bed level with Printbite is essential and the initial first physical layer height. Once set it is a whole new experience. Including easily removing the printed object after cooldown 🙂 All that is needed is an occasional wipe with Isopropyl alcohol , to remove any grease from fingerprints on the bed. I have added Printbite to my Hobbyking Turnigy Fabrikator mini 1.5. Once level set, it works well, considering no heated bed.

I use Printbite on my Ultimaker 2+, my Large (Hobbyking Fabrikator) and my Hobbyking Fabrikator Mini 1.5.

I am looking forward to my preorderd MK2 upgrade to my Genuine Prusa I3 Mk1 that I purchased a few weeks ago. < The Mk1 I mean. My Mk1 is a few weeks old.