Benachrichtigungen
Alles löschen
Iron Function?
Hi all,
Just was watching this Youtube video about §d printing and heard about this Iron Function. Sounds super useful for many of the prints that I am doing. This function uses the hot nozzle at the end of the print on the last layer to Iron it smooth.
Does this funtion exist for the Prusa using either Prusa Control or Slic3r?
You can see more here on this video:
at 25:15+
Many thanks
Benjamin
Veröffentlicht : 18/02/2018 7:48 pm
Re: Iron Function?
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…
Veröffentlicht : 18/02/2018 8:24 pm