How can I prevent this from happening in future prints?

Dernier message

RSS

Ender

(@ender)

Active Member

How can I prevent this from happening in future prints?

Hello all. Just built my MK2S and after a few successful prints went ahead and tried printing the castle that comes in the SD card. Unfortunately, 11 hours un I noticed this stringing by the entrance to the castle:

Any tips or tricks or changes that you guys/gals can recommend to prevent this in future prints?

Thanks in advance for your time and help.

Publié : 19/11/2017 4:32 pm

Statistiques du forum

559 Forums

62.3 K Sujets

440 K Messages

20 En-ligne

67.7 K Membres

Le dernier des messages: Prusament Woodfill Linden Light Filament profile? Notre nouveau membre: sonic bionic Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé