Benachrichtigungen
Alles löschen

HeatBed power cable broken  

Seite 2 / 2
  RSS
serge.k
(@serge-k)
Active Member
Themenstarter answered:
Re: HeatBed power cable broken

Serge

The key here is that it's working. Leave it alone; if it stops working in the future, then you fix it. If it's not broken don't fix it.

I tend to agree, but my concern is that through a bad connection in a high power item like the heatbed, it might result in worse problems after some time, ...like the board frying, or a fuse burning out or such ...

I really would be happy to see some more pics of the heatbed connection on other printers... so feel free to post yours ppl 🙂

thanx and happy printing 🙂
Serge

Veröffentlicht : 05/11/2016 11:53 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: HeatBed power cable broken

Serge

You don't have a high current on the LED; that is limited by the new resistor you put in place to somewhat less than 20mA.

The high current is purely for the heater element.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Veröffentlicht : 06/11/2016 11:08 am
Seite 2 / 2
Teilen: