English
Forums
English forum
Original Prusa i3 MK2/S
Others (Archive)
Heatbed Burn after 3/4h of print
 
Notifications
Clear all

Heatbed Burn after 3/4h of print  

    Last Post
  RSS
giuseppe.p
 giuseppe.p
(@giuseppe-p)
Active Member
Heatbed Burn after 3/4h of print

Hello,

I have a problem with my printer that after 3 or at max, 4 hour of printig, burn the Heatbed connectror.

We have never had this problem? How I can solve?

I'm very worried for the electrical board.

Regards

Posted : 18/09/2017 3:30 pm
AJS
 AJS
(@ajs)
Noble Member
Re: Heatbed Burn after 3/4h of print

http://shop.prusa3d.com/forum/prusa-i3-kit-building-calibrating-first-print-main-f6/melted-terminal-block-for-heater-bed-t86.html#p23534

Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…

Posted : 18/09/2017 3:36 pm
  All forum topics
  Previous Topic
Next Topic  
Share: