Benachrichtigungen
Alles löschen

happy but frustrated  

  RSS
Emil
 Emil
(@emil-3)
Active Member
happy but frustrated

I finished this morning to assemble Original Prusa i3 MK2 .
But when I clicked power on button ... nothing happened ! I retried two or three times and seemed to have no power at all . I clicked the LCD-knob and all I get is a beep ( short and severely followed by long and sharp ).
I checked 3-4 times electonic assembly and I have no idea where is the problem! 😕 Please, I need help!!

Veröffentlicht : 25/06/2016 10:01 pm
andersonta
(@andersonta)
Eminent Member
Re: happy but frustrated

Does the LED for the power supply at least come on? You do have the proper AC voltage selected?

Veröffentlicht : 25/06/2016 10:05 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: happy but frustrated

Emanual

Best guess is that you have the LCD cables on the RAMBo the wrong way round. Ensure that the location lugs are pointing inwards towards the centre of the board; post a picture if you are unsure.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Veröffentlicht : 25/06/2016 10:51 pm
Emil
 Emil
(@emil-3)
Active Member
Themenstarter answered:
Re: happy but frustrated

Green LED its ON in the Power Supply and 220V selected.

Veröffentlicht : 25/06/2016 10:53 pm
Emil
 Emil
(@emil-3)
Active Member
Themenstarter answered:
Re: happy but frustrated

I see the video cant be uploaded. I check again and dont see no problem with the LCD cables. I dont have no ideea where is the problem!

Veröffentlicht : 27/06/2016 10:01 am
Emil
 Emil
(@emil-3)
Active Member
Themenstarter answered:
Re: happy but frustrated

I hope you cant see where its my problem here! Thank you for help!

Veröffentlicht : 27/06/2016 10:12 am
Emil
 Emil
(@emil-3)
Active Member
Themenstarter answered:
Re: happy but frustrated

I forgot the most important , as we have Rambo cable connected to LCD.

Veröffentlicht : 27/06/2016 10:37 am
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: happy but frustrated

Emanuel

You have the RAMBo LCD connector wrong way round: https://d17kynu4zpq5hy.cloudfront.net/igi/prusa3d/AneXQaOWIhrrEcLN

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Veröffentlicht : 27/06/2016 11:02 am
Teilen: