GCode for message with pause
Hello,
is there a GCode that pauses the printer and waits till a button is pushed?
Like M71 from Sailfish firmware
regards
Bastian
Re: GCode for message with pause
You could try M583, wait for pin. Wire a push button to an unused endstop input and set it to wait for that. Haven't got my Mk2 yet though, so can't test it.
Re: GCode for message with pause
Is the button not also a "pin" ?
Re: GCode for message with pause
I'm not 100% sure, as it's connected through the LCD interface. That's why i suggested an unused endstop input, as that's deffinitely a pin.
Re: GCode for message with pause
M583 is not implemented in PR Marlin.
This has been asked previously and I think that the use of M600 (filament change) was the best outcome.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…