English
Forums
English forum
Original Prusa i3 MK2/S
Others (Archive)
GCode for message with pause
 
Notifications
Clear all

GCode for message with pause  

    Last Post
  RSS
Slash200
 Slash200
(@slash200)
Eminent Member
GCode for message with pause

Hello,

is there a GCode that pauses the printer and waits till a button is pushed?
Like M71 from Sailfish firmware

regards
Bastian

Posted : 10/04/2017 8:05 pm
Alan
 Alan
(@alan)
Eminent Member
Re: GCode for message with pause

You could try M583, wait for pin. Wire a push button to an unused endstop input and set it to wait for that. Haven't got my Mk2 yet though, so can't test it.

Posted : 10/04/2017 9:07 pm
Slash200
 Slash200
(@slash200)
Eminent Member
Topic starter answered:
Re: GCode for message with pause

Is the button not also a "pin" ?

Posted : 10/04/2017 9:12 pm
Alan
 Alan
(@alan)
Eminent Member
Re: GCode for message with pause

I'm not 100% sure, as it's connected through the LCD interface. That's why i suggested an unused endstop input, as that's deffinitely a pin.

Posted : 10/04/2017 9:45 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: GCode for message with pause

M583 is not implemented in PR Marlin.

This has been asked previously and I think that the use of M600 (filament change) was the best outcome.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 11/04/2017 11:35 am
  All forum topics
  Previous Topic
Next Topic  
Share: