Notifiche
Cancella tutti

First Test Print  

  RSS
Chuck76
(@chuck76)
Active Member
First Test Print

I just finished assembling the MK2S today and being new to 3D printing I'd appreciate some comments on the first printed part. I'm not sure if the height of the filaments is too low or to high. The part was printed using the stock settings in the g-code.

Chuck

Postato : 13/01/2018 12:16 am
lee.g
(@lee-g)
Estimable Member
Re: First Test Print

I would say first layer needs to be a little lower although you are very close to it being perfect.

The rest of the model looks a little over extruded.

For my eyes you don't have any major problems there you just need a little time to fine tune and you will be getting great prints.

Postato : 13/01/2018 8:18 am
Condividi: