Notifications
Clear all

Filament is delayed  

  RSS
giovanni.f
(@giovanni-f)
New Member
Filament is delayed

I've been printing happy for months and haven't had any issues until now. Whenever i run a print, the filament is delayed by a fraction of a second. I don't think its the g code itself because i tried a print using a g code i know has given me good results in the past. This issue is consistent, it happens every time, even on the little strip of test filament it does before the actual print. This issue is causing all my prints to fail. I've tried re calibrating, updating the firmware, cleaning the bed, different filaments but to no avail. Has anyone ever had this issue or could perhaps suggest an area to investigate?

Thanks in advanced for any help.

-Gio

Opublikowany : 24/03/2018 6:19 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
Re: Filament is delayed

I had that problem when i used the wrong version of Slic3r

I think I used the MMU version in error

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Opublikowany : 24/03/2018 6:56 pm
Share: