Notifications
Clear all
Filament coming out of extruder nozzle on idle
Hello,
I recently purchased and setup a i3 mk2 kit, and I'm experiencing some problems with the extruder.
On idle, with the filament loaded, the extruder seems to be leaking filament from the nozzle. Is this normal?
Napsal : 30/11/2016 5:59 pm
Re: Filament coming out of extruder nozzle on idle
Jeffrey
Absolutely normal. There is nothing holding the molten filament in the nozzle so it will ooze out until it is empty.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Napsal : 30/11/2016 7:17 pm