Notifications
Clear all
Fan disabled for first 3 layers but still works
Hello all,
i have Slic3r ver 1.35.5.16 and Prusa MK2 Firmware 3.0.12. My fan is spinning first 3 layers even i 'disabled fan for the first' 3 layers.
See picture
Any ideas?
Napsal : 27/07/2017 4:06 pm
Re: Fan disabled for first 3 layers but still works
http://shop.prusa3d.com/forum/software-f13/changed-1st-layer-fan-settings-or-bug--t5202.html#p37691
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…
Napsal : 28/07/2017 4:27 am