Notifications
Clear all
Failure to load 3D model in PrusaControl
Sorry, I have problems with PrusaControl, I do not understand why I can not see any models I load in PrusaControl.
I created a simple 1 cm cube with my 3D program
saved in STL
imported into PrusaControl I see nothing ..
It should be simple, no?
Where am I wrong?
Do I have to do other steps before?
I tried on Mac and Win
Publié : 14/12/2017 5:51 pm
Re: Failure to load 3D model in PrusaControl
I have had the same problem a few times. It turned out that what I imported from as a .stl was at such a small size, when imported, I could not see it. I up scaled until I could.
Hope that helps,
Neal
Publié : 14/12/2017 6:43 pm
Topic starter
answered:
Re: Failure to load 3D model in PrusaControl
I'll try, thank you!
Publié : 18/12/2017 8:26 am