Extrusion Multiplier does not work?
 
Notifications
Clear all

Extrusion Multiplier does not work?  

  RSS
julian.b
(@julian-b)
New Member
Extrusion Multiplier does not work?

Hello,

I've got a new Prusa i3 MK2, and it prints fine with the preset values for the filaments as offered in Slic3r Prusa Edition 1.33.8.
But when I try to finetune the extrusion multiplier, eg. modifying the value from "1.0" to "1.01" or "0.99", the printer starts to extrude far too much or nearly nothing. E.g. with the setting "0.99", which is actually only 1% less, nearly nothing seems to come out of the nozzle any more, except some fine strings looking like cobbweb. I tried it with 100 um setting. Is it possible that such fine steps are not possible?

Thank you
regards
Julian

Opublikowany : 22/03/2017 7:58 pm
Share: