Err: MINTEMP BED (Solved)
I'm new here. Just received my first 3D printer 3 days ago. Prusa MK2 i3. I love it, nice work Prusa Team.
Install was fun a bit like legos.
Managed to get 2 prints done and now I have an ERROR on the Mintemp on the bed.
I checked my connections and they seem ok.
Not sure if I need to test my fuses on the ROBO board.
I tried a factory reset but the same error is present.
Any other trouble shooting ideas?
Hope this is something simple...
And it was simple, did some more research, my garage is too cold, so overnight it went below the min temps required. Busted out a hair drier and pre heated it slowly and turned back on and away we go.
Re: Err: MINTEMP BED (Solved)
Same error happens if the thermistor goes open circuit.
the heat shows below 15c even when it's obviously above 15c...
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK