Notifications
Clear all
calibration v2 question
When I try calibration v2 gcode it doesn't lay the filament in the air but rather lays it on bed nicely. I never tried live adjust Z as it looks good to me as-is. Based on the photo does it look correctly calibrated?
Napsal : 30/05/2016 12:20 am
Re: calibration v2 question
Calibration starts rather on the safe side, so usually begins higher above the heat bed. Based on photo it looks good, I would still rather slightly adjust height to have nozzle little bit lower.
Napsal : 30/05/2016 8:44 am
Re: calibration v2 question
I think prusayo calibrated before and the calibration settings carried over tho next calibration. You can tweak the calibration as many time as you want.
Founder and owner / Majitel a zakladatel
Napsal : 30/05/2016 10:02 am