Notifiche
Cancella tutti
Calibration issues
Took a video of calibration as it started acting weird. Seems to climb away from the plate. When I try to manually adjust z it only goes up.
On further inspection it seems my pinda probe isn't lighting up and a self test returns an end stop z error. I'm thinking the probe has gone bad?
Postato : 22/07/2016 6:18 am
Re: Calibration issues
Hi Brent
Contact support - use "Live Chat" on the shop page. Give them a link to this thread.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Postato : 22/07/2016 9:19 am